3D-Maker

All About 3D Printing
 
3D-Maker

Switching to RAMPS 1.4 – Firmware [ANET]

Download preconfigured configuration.h for the 12864 or 2004 LCD without autoleveling for Marlin 1.1.x: Updated for Marlin 1.1.9! Installing Arduino IDE, Download Marlin Go to the Arduino Homepage and chose your operating system, download Arduino IDE and install it. Download the newest Marlin firmware by clicking on the “Clone or …

Switching to RAMPS 1.4 – Wiring [ANET/TronXY]

Hardware You can either buy a full kit or all parts individually. Buying a kit is mostly cheaper and therefore is recommended. These kits are either available from amazon or the typical chinese vendors. Banggood Gearbest Stepper Drivers Update: Got my DRV8825 drivers and i can’t recommend them because the …